Remote command killed & keepalive

Hello all,

I wanted to know for how much time are remote commands kept on the management server, and if they are "killed" after a reboot of the client being scanned.

I am asking this because sometimes, when i launch a remote command of full scan, either the endpoint does not send the logs or the management server does not receive them. Some commands are shown as "In progress" when in fact they appear to be completely stopped, even after a reboot.

If the commands are being killed after a reboot, is there any way to resume them from where they were? Or does the command have to start all over again?

Let me know,

Thanks,

Alessandro